主拱圈浇注方案(国外英文资料).docVIP

主拱圈浇注方案(国外英文资料) The main arch ring concrete casting construction plan First, the general situation of the project The wangjijia river bridge is located in the youth east road of yueyang city, which is (35 + 50 + 35) m 3 cross-reinforced concrete box arch bridge, the bridge center pile number K1 + 578.5, the bridge width 35m, the length 168.188 m. The reinforced concrete box arch is a single-case multi-chamber arch, which is the solid section of the shaft of the arch in two meters. Two meters apart, the sides are separated into seven compartments by one meter and 0.5 meters respectively, separated by one meter and 0.5 meters respectively, and separated into 10 Chambers. Second, the main project quantity The number of concrete projects in the main arch is 3832m? ; The main arch is 890t. Three, the construction plan, the method (1) construction plan: According to the design of the construction and the actual construction of the site, the scheme of the casting of the layered section along the axis of the arch axis is proposed. Each arch is divided into three sections along the main arch axis. The first paragraph is the arch of the arch to the nearest wall of the arch. The second paragraph is near the arch and the nearest wall to the other side of the wall; The third paragraph is the symmetry of the wall to the other. A total of 2 places will be set and the width is 80-100cm. Using commercial concrete, concrete pouring sequence is: the backplane, web plate and diaphragm post-cast strip, roof, symmetrical pouring construction, arch foot 2 meters solid abdomen section of a casting molding. Note: the above near arch is recently erected in the wall of the vertical wall and the arch of the abdominal arch, which is 3 #, 4 #, 8 #, 9 #, 13 # and 14 #. (2) construction methods: After preloading, the bottom of the main arch bracket die on the bottom die to re-mark bridge, the central axis plane position of box girder lofting, marked on the bottom die clapboard, the lateral abdomin