压力容器设计校核人员考试试题及答案(国外英文资料).docVIP

压力容器设计校核人员考试试题及答案(国外英文资料) Pressure vessel design school nuclear staff exam questions and answers (C) Unit name score One, fill-in-the-blanks: (2, 44) 1, the fixed rules of the pressure vessels safety and technical rules of thickness delta of 12 mm or carbon steel and low alloy steel plate (not including multi-layer pressure vessel layer board) used in the manufacture of pressure vessel shell, conform to one of the following conditions, shall be ut before ultrasonic testing: (1) loading medium degree of toxicity to extreme, highly harm; (2) used in a wet H2S corrosion environment; (3) design pressure is greater than or equal to 10MPa; (4) ultrasonic testing is required in the reference standard. Steel plate ultrasonic testing shall be according to JB/T 4730 nondestructive testing pressure equipment regulation, the first (1), the first (2), the first paragraph (3) of the steel plate, the qualified level is not lower than Ⅱ, subparagraph (4) of steel plate, qualified level shall comply with the provisions of the corresponding reference standard. 2, design of pressure vessels with gray cast iron, pressure is not greater than 0.8 MPa, the design of 10-200 ℃ temperature range. 3, pressure vessel design unit based on the design conditions, should consider all relevant factors and failure modes and enough safety margin, to ensure that the pressure vessel has sufficient strength, stiffness, stability and corrosion resistance, and at the same time should also consider skirt, leg, lifting lugs and pressure vessels, such as the main body of welded joint strength requirement, ensure the safety of pressure vessels within the design life. For the third type of pressure vessel, the risk assessment report shall include the main failure mode and risk control. The wall thickness of the main compression element of the simple pressure vessel is determined by experiment method or calculation method. The actual thickness of the shell is not less than 1 mm, the simple pressure vessel of ca