吊车梁施工方案(国外英文资料).docVIP

吊车梁施工方案(国外英文资料) Figure 3: assembling the location diagram Welding process requirements Selection of welding equipment and welding materials The crane girder steel is Q235B, the steel plate butt seam and the t-shaped arc automatic welding welding (MZ1000), dc reverse, the choice of H08A wire and HJ402 welding agent; Manual welds adopt E4315 electrode. 6.2 position welding When the plate is docked, the welding position of the weld at the back of the initial pass is welded. When assembling the crane girder, the welding seam is used for welding welding. Position weld length, thickness and spacing require the following table: Joint form Weld length/mm Weld thickness/mm Weld spacing/mm Plate butt 20-30 5 500-500. T joint 80-80. 8 400 Welding process parameters of 6.3 arc welding Joint form Pass sequence Wire diameter mm Welding current a. Welding voltage V Welding speed Cm/min Stem elongation mm Plate butt The delta 14 The first layer 5 400-400. 31-32 44-46 30 to 40 The delta 25 The first layer 5 500-500. 31-32 44-46 30 to 40 The second floor 5 500-500. 32-34 44-45 30 to 40 T joint The first layer 5 500-500. 31-32 44-46 40-45 The second floor 5 500-500. 32-34 44-45 40-45 The operation requirement of the submerged arc welding Before the arc welding, if the interface has clearance (greater than 1mm), the thin layer of welding on the back of the initial welding layer should be applied by manual arc welding. Position weld and hand welding temporary sealing weld shall be cleaned before the initial welding and avoid the unsoldering. Before welding, first of all, should adjust the car track parallel to the center line of the groove, and the distance in the range of the nose lateral adjustable, and let the car empty run in the groove center line, can enter the normal welding. When welding, the arc and arc of arc must be in the lead, stop arc. The direction of the welding process is always in one direction. Prior to welding, the first layer of weld shall be cleared. After the cove