湖北定额计算规则(国外英文资料).docVIP

湖北定额计算规则(国外英文资料) The calculation rules of concrete engineering quantity are given The present concrete projects shall be calculated according to the following provisions In addition to other regulations, the concrete volume shall be measured in cubic meters according to the size of the actual volume. The size of the hole in 0.3 square meters of the steel bar, the embedded iron and the wall and the plate are not deducted. 2, basis: (1) the concrete foundation is divided into the wall or column, and the roof is bounded by the foundation. (2) the frame equipment foundation shall be calculated according to the basis, column, beam and board. The equipment foundation on the floor is calculated according to the beam plate quota project. The value of the anchor bolts is not included in the equipment base quota. The anchor bolts should be included in the value of the complete set of equipment, such as the value of the anchor bolts not included in the value of the set of equipment, and the bolt should be calculated according to the actual weight. (4) the first order of the same cross section is based on the bar form of the template, and each is carried out in accordance with the corresponding quota project; The ribbon foundation, which is not used in the form of a template, is carried on the concrete foundation floor of this chapter; The concrete pad of the template is executed according to the corresponding quota of this chapter. (5) cup base of neck to 1.2 m tall (at the top of the foundation to expand to the glass bottom), according to the corresponding column norm execution, its section at the top and base combined calculated on basis of cup. Column: the dimension of the section of this diagram is multiplied by the column height. The column height shall be determined by the following rules: (1) the column height of the beam board shall be calculated from the surface of the cylinder to the surface of the floor. (2) the column height of no beam board shall be calculated fro