离心泵的检修周期与内容(国外英文资料).docVIP

离心泵的检修周期与内容(国外英文资料) The maintenance cycle of centrifugal pump and the quality standard, test car and inspection 1 the general The theme content of 1.1 is limited 1.1.1 this procedure rules the maintenance cycle of centrifugal pump and its contents, inspection and quality specification, trial and acceptance, maintenance and fault disposal. 1.1.2 procedures for the use of centrifugal pumps in petrochemicals. Write a revision basis The sy-21005-73 refinery centrifugal pump maintenance procedure The HGJ 1034-79 chemical field clean water pump and metal corrosion-resistant pump maintenance procedure The HGJ 1035-79 chemical field centrifugal heat pump maintenance procedure HGJ 1036-79 chemical field multi-stage centrifugal pump maintenance procedure GB/T 5657-1995 centrifugal pump skill requirements APl 61, 1995 oil, heavy chemical and natural gas industry centrifugal pump Maintenance cycle and content 2.1 service period 2.1.1 can adjust the repair cycle properly according to the result of the morphological monitoring and the operation of the equipment. Maintenance cycle (see table 1) Table 1 checks the periodic table Maintenance categories Minor repair overhaul Repair cycle 6 18 2.2 maintenance content Minor projects Change the packing seal for 2.2.1.1. 2.2.1.2 double support pump self-reflective cleaning bearing, bearing box, oil ring, water stop ring, oil mark, etc., adjust the clearance of bearing. 2.2.1.3 reflect on the fixing of the coupling and the control of the pump. The common defects presented in the operation are handled by 2.2.1.4. 2.2.1.5 reflect the system of cooling water, sealing oil and smoothing. Project 2.2.2 2.2.2.1 covers minor projects. 2.2.2.2 check for mechanical seals. 2.2.2.3 to reflect on the wear, erosion and erosion of the parts. The pump shaft and impeller are required to carry out non-destructive inspection. Check the bearing, oil seal, etc., to measure and adjust the oil seal clearance. 2.2.2.5 introspection to measure the movement and cl