SBR常识点(国外英文资料).docVIP

SBR知识点(国外英文资料) Traditional SBR method Water phase: acceptance of wastewater, the process of reaction pool in the waste water into the drainage or idle state before the previous cycle, so the reaction pool contains a high concentration of active sludge mixture. When the waste water enters the reactor, the water level gradually rises, and when it reaches the highest water level or set time, stop the water. Since the water intake phase only flows into the waste water and does not discharge water, the reaction pool has the function of regulating the pool. Reaction stage: when the wastewater is injected into the desired volume, the gas or the mixing reaction is carried out to remove the organic matter, nitrification and removal of the phosphorus. If the aeration is carried out, the system is in a good oxygen state, and through the aerobic reaction, the oxidation of organic matter, nitrification of ammonia and phosphor reaction are realized. If mixing, and the presence of electron donor and electron acceptor, the system in hypoxia state, through the anoxic biological response, realize the denitrifying nitrogen and oxygen absorption of phosphorus. If you dont aeration system, only for mixing or static, and the presence of electron donor, the system is in anaerobic condition, organic matter through anaerobic reactions anaerobic nitrate, and anaerobic phosphorus release. Precipitation stage: stop aeration and stirring, this stage is equivalent to the two sinks of traditional activated sludge. The sludge is separated from the solid liquid by the gravity subsidence, and the cleaning fluid is cleared. The sedimentation is highly efficient (1.5-2h) because of the static subsidence. Drainage period: the discharge of the liquid as a result of the precipitate, the discharge of the discharge, the lowest water level. At this time, some residual sludge is also discharged, and the residue of activated sludge in the reactor is used as the mud. Idle time: when the water is discharged, t