反转展转窑筒体结构变形处理技巧和方法(国外英文资料).doc

回转窑筒体结构变形处理技术和方法(国外英文资料) The technique and method of deformation of rotary kiln tube structure Keywords: cylinder deformation control belting leather red kiln cylinder plate neck buckstay additional stress pressure supporting method Dig repair method Cylinder bending repair method Rotary kiln production process often appears the phenomenon of cylinder deformation, then need to carry out the processing of rotary kiln tube structure, including the structure of the kiln head adjustment of rotary kiln, the concrete treatment method is below. In order to guarantee the efficiency of the rotary kiln, the geometrical shape of the straight and round cylinder must be kept. But due to the violation operation procedures, such as kiln without turning kiln according to regulations, or local brick fall off set fill not in time, or stop caused by the special kiln after long-term cannot turn (such as sealing ring burn out, all of a sudden power outage, roller damage, etc.) tube bent, serious when, belting leather and wheel out of contact, or even change the fixed kiln phenomenon. In this case, use the auxiliary motor to turn the kiln slowly, until the big motor can be turned into the kiln. In the slow turning kiln, the kiln body gradually returns to normal after a slow turn, and then is adjusted according to the load of the torus. After bending, such as kiln auxiliary motors turn kiln can only turn half circle, then turn the kiln body bending of arch to the above, then stop kiln fire, make the kiln cooling, curved arch department will slowly back to normal, and then open kiln ignition. Rotary kiln after deformation, look from the ammeter kiln motor current is not stable, easy happening kiln brick, belting leather with roller contact, serious when caused the phenomenon such as belting leather shift. Can water spray be treated on the tube of kiln head? When the kiln is bent, it is usually non-water treatment, and the method of continuous rotary kiln is used to make the kiln natural r