地下室剪力墙施工计划(国外英文资料).doc

地下室剪力墙施工方案(国外英文资料) Basement shear wall construction plan 1, engineering overview The building is divided into sections A and B, all set up in the basement. Basement wall For shear wall, shear wall thickness is divided into 350mm, 300 mm, 250 mm, 200 mm. The concrete strength grade is C35, and two rear water belts are set up, according to the following, the construction is divided into A, B, C and three sections. The anti-permeability rating is S6. The shear wall concrete structure is 410M3. Schedule 2 The basement shear wall concrete casting plan was set up on October 11, solstice12, the section of A section, October 14-15, the B section, the October 20-21, the section of the C section, and the plan to cast 80M3 every day and night. It will take five days to complete the entire pouring. Construction plan Consider the driving and parking locations of automobile pumps and concrete transports as follows: When casting A shear wall of A, the car pump is parked inside the front door of the construction site, and the concrete transporter is coming in and out of the factory gate. The car pump is parked in the inside of the door when the car pump is in the outside of the door. 3.3, pouring shear wall, consider car pump and pump combination, at the same time operating casting drag pump park gate inside the construction site, concrete truck from the factory gate to gate at the site. 4, construction preparation, Prepare the scene 4.1.1 shear wall steel construction finished, and the inspection engineer is qualified. After 4.1.2, the water belt shall be welded, fixed and firm, 4.1.3 shear wall to check and check and check The construction water will be connected to the construction site 4.1.5 construction electricity should be equipped with the power supply according to the general plan, and should be equipped with four mobile three-level distribution boxes, which can be used at the same time for six vibrators. The site should be equipped with a backup diesel generator with a p