大偏压与小偏压处理计划比拟(国外英文资料).docVIP

大偏压与小偏压解决方案比较(国外英文资料) The big bias is compared to the small biased solution The eccentric compression component is calculated by the cross-section bearing capacity The damage characteristic of the cross section of the eccentric compression component (1) damage type Tensile damage: when the eccentricity is larger and the tensile steel is not configured too much, the damage is a great bias. This type of damage is characterized by the ability of the reinforced concrete in the zone of tension and pressure to yield, and the concrete in the compression zone can also meet the extreme pressure strain, as shown in figure 7-2a. 2, compressive failure: smaller or when the eccentricity is very small, or although larger relative eccentricity, but at the moment is configured with a lot of steel, the damage is a little bias. The damage characteristic is near the longitudinal force yield can reach the end of the steel, concrete crushed, and away from the longitudinal force to the end of the steel in tension and compression, usually issued less than give in. ? The demarcation of the boundary damage and the partial pressure of the scale 1, limit damage In theory, there is a kind of boundary damage state between big eccentricity and small eccentric compression. The pressure strain of the concrete on the edge of the compressive zone is exactly the limit of the stress strain when the tensile strength of the tension zone reaches the yield. This special state can be used as a boundary between the size bias and the size bias. The difference between the two is whether the steel bar in the zone is in submission. The dividing line of the partial pressure Due to the high eccentricity compression and the structural failure of the bending component, the ratio of the ratio of the relative pressure region is also assessed. When? When the cross section is a big bias; At the time, the section was a small bias; At the time, the cross section was in a state of boundary. The eccentric compression comp