大工11秋《钢筋混凝土结构》在线功课2(国外英文资料).doc

大工11秋《钢筋混凝土结构》在线作业2(国外英文资料) 11 autumn reinforced concrete structure online work 2 One, single topic (total five questions, total 30 points). The maximum shear stress occurs in (B) of the rectangular cross section. A. short edge B. the long edge C. Angle Its hard to say Full marks: 6 The method of reinforcement of the torsional component can be divided into (C). A. only the twisted band is configured B. only the twisted tendon is configured C. configure torsion and twist Not sure Full marks: 6 The shear ability of the component is (B) due to the presence of longitudinal pull in the tension component. A. improve B. to reduce C. the same Not sure Full marks: 6 The reason that the concrete slab does not need to be sheared is (D). A: only the bending moments do not apply The section of the board is too small to be equipped with a hoop C. the bending of the plate is sufficient for shear shear D. The shear value of the computed cross section of the board is smaller, satisfying less than or equal to c Full marks: 6 The shear bearing capacity (A) of the cross section of the same beam when the load is concentrated or the load is uniform. A. The load of the uniform is large The concentration load is large Not sure They are the same Full marks: 6 Two, multiple-choice (18 points in total). In the case of the bending member, the bending moment must be drawn in the case of (BCD). A. Only A short support beam with A brace B. there is a strong arm beam C. do not set the bending beam D. set up the bent beam Full marks: 9 The characteristic of the torsional fracture is (ACD). A. and component axis is roughly 45 ° B: its intermittent C. continuous helical Full marks: 9 (13 questions, 52.) The torsional capacity of the hypertensive component depends on the tensile strength of the concrete. A. mistakes B. right Full marks: 4 The reinforcement ratio should not be less than 0.8% for reinforced concrete. A. mistakes B. right Full marks: 4 In the shear mechanism of the beam inclined section