广联达钢筋2009中搭接设置(国外英文资料).doc

广联达钢筋2009中搭接设置(国外英文资料) Ganda bar in 2009 The software defaults to the section of the steel bar diameter: 1, the level of steel: (1), 3 ~ 10. (2), 12 ~ 14. (3), 16 ~ 22. (4), 25 ~ 32. 2, secondary steel: (1) 3 to 11.5. (2), 12 ~ 14. (3), 16 ~ 22. (4), 25 to 50. 3, level 3 steel: (1), 3 ~ 10. (2), 12 ~ 14. (3), 16 ~ 22. (4) 25 ~ 50. As shown in figure 1: ? Due to the steel bar is the version of software, so the division of the steel bar diameter is not necessarily suitable for every region, so should undertake adjustment according to their own local regional quota specification. Example: hebei on the quota description rules reinforced joint design drawings has stipulated according to the design drawings calculation; if there are no relevant provisions in the design drawings, the level of the cast-in-place concrete long reinforced lap quantity, diameter of less than 25 mm, according to the 8 m long, a joint diameter 25 mm above a joint by 6 m length, lap length calculation. As stipulated in the specification and design of cast-in-place concrete vertical pass long steel (reinforced) refers to the vertical wall, column as well as stipulated in the above calculation, but the height is less than the specified vertical reinforced joint, joint spacing per natural layer of a calculation. From the above content, can know hebei steel bar diameter specified length divided by 25 diameter steel line, less than or equal to 25, should be all calculated according to the specified length of 8 meters, more than twenty-five (25) does not include the 6000 a street to calculate. So when our engineering in the comparison of steel bar diameter 25, according to the software default bar diameter of section is not appropriate, so we need our own combined with local norm to readjust to divide the diameter of the steel section. ? The diameter of the steel bar is larger than 25, and the diameter is 28. 1, the level of steel: (1), 3 ~ 10. (2), 12 ~ 14. (3), 16 to 25. (4), 28 ~ 32. 2, secondary st