11G101中钢筋的绑扎搭接长度的计算(国外英文资料).docVIP

11G101中钢筋的绑扎搭接长度的计算(国外英文资料) In general, C20 concrete is not used as the strength grade of slab concrete, so this predecessors example is a problem example. We can see from 11g101-153 that the 400 and 500 steel bars of the beam board are - in the corresponding C20. Above all, the new atlas will be able to directly look up the 99.99% of the anchorage and connection. Compared to the 03G101 series, the lack of only the 28mm steel and epoxy resins coated in steel and epoxy resin. And the first, two, three ji, four and non-aseismic are placed in one form, saving space, convenient for reference and use. 5, someone climb a shout: 11 g101 atlas of anchorage length cannot be directly look-up table, need to take a coefficient, the whole world steel were perceived 11 g101 anchorage length cannot be directly look-up table, need to take the coefficient, this is just the base of the new information age, not standard and atlas of the facts about steel bar anchoring length. 6, a lot of people are not quite sure what the difference is between la, laE, lab and labE in the 11g101-1 atlas. Hopefully, the following readings will do more or less for you: The atlas is already marked by the fact that, in the case of a single integer, it is the la (which is corrected), which is the same as the la ( laE ); Anyone who is not an integer, but less than or greater than 1, is the need to use 0.35, 0.4, 0.65, 1.2, 1.5, 1.7, and so on of different coefficient of correction of the lab (labE). At this point their la is 0.4 lab, 0.65 ab, 1.2 ab, 1.5 ab and 1.7 ab; Their laE are 0.4 labE, 0.65 abE, 1.2 abE, 1.5 abE, 1.7 abE. Of 11 g101 colligation lap length of reinforcement calculation in 11 g10 series atlas, 11 g101 g101-2-1, 11, 11 g101-3, on page 55, 18, 56, respectively is: the longitudinal tensile reinforcement assembling lap length, Ll LlE, a table. There is an anti-seismic formula: the LlE = zeta llaE and the non-seismic formula: Ll = zeta. The zeta l in the formula of zeta llaE and Ll = zeta i