智能变电站线路爱惜装备(国外英文资料).docVIP

智能变电站线路保护配置(国外英文资料) Intelligent substation line protection configuration Compared with traditional substation, the process layer of intelligent transformer substation increases the unit and intelligent terminal. This also brings some changes to the relay protection device and related configuration. A brief introduction to line protection configuration of 220kV and above voltage level in intelligent station. 1, the configuration principle The relay protection and related equipment and network of 220kV and above voltage level shall be configured according to the principle of double ization. The secondary protection of dual configuration should follow the following requirements: (1) each independent protection device should be able to handle all possible fault types, there should be no electrical connection between two sets of protection, a set of protection exception or exit shall not affect the other a set of protection operation, it is the same as the traditional station. (2) the current and voltage sampling values of two sets of protection shall be taken separately from each other. (3) the two sets of two separate sampling systems for each transformer are respectively corresponding to the dual configuration of MU. (4) the dual-ized GOOSE/SV network that protects USES should also be independent of each other, corresponding to the two process layer switches. When a network exception or interrupt, it should not affect the running of another network. (5) the trip circuit of two sets of protection shall be the two intelligent terminal correspond respectively, two intelligent terminal should with the circuit breaker tripping coil respectively. (6) protection devices, intelligent electronic devices such as intelligent terminals mutually start and atresia, location between state can exchange information through chicago-brewed GOOSE network transmission, such as the protection of the dual configuration between the direct exchange of information. (7) the protective device s