曝气沉砂池(国外英文资料).docVIP

曝气沉砂池(国外英文资料) In this design, an aeration sink is used in the design, and each sink has N = 2 sinks. The design flow was 0.775. Design parameters The horizontal velocity is designed to be 0.1 m/s. The duration of the peak period is one to three minutes. The effective water depth of the sink is set to 2.0 ~ 3.om, which is suitable for the depth of the pool and the depth of the pool. Generally, the amount of air needed to deal with each cubic meter is 0.1 ~ 0.2 air quantity, and the sediment sink can be calculated by 0.03 L per cubic meter. The direction of water inlet should be used in the same direction as the water flow direction in the pool, and the vertical direction should be chosen as the outlet. 6, the sand bucket size should be reasonable setting, should be less than two days of heavy sediment, when heavy sand sand bucket with gravity drainage design, settling pit sand around fights the wall Angle increased, as far as possible in general Angle is greater than 55 ° effect is good. The bottom of the sink is designed with incline, and the bottom of the pool slope is 0.1 ~ 0.5. The design calculation of aeration sink The effective volume of sedimentation pond Type: In this design, it is equal to 2 2, the area of the flow area Type in the Design for = 0.1 3, total width of the pool The width of the sink in the type, The sink is deep in water. Design for = 2.5 Between 1.0 and 1.5. 4, long pool The amount of air needed per hour The amount of air required for each hour of the type; The amount of air needed for a sewage. Design = 0.2 sewage The volume of the storage bucket is required The amount of sewerage in type urban sewage is equal to 30 sewage The spacing of the sand is set = 2. The volume of each sink is calculated as follows: The size of the sand sink In the design of the bottom half of the bucket, the Angle of tilt of the incline, the sand bucket height Based on the above data, we can calculate the size of the bottom surface of the bucket. The effective volu