止口与反止口(国外英文资料).docVIP

止口与反止口(国外英文资料) The main points of the design of the stop and reverse stop are divided into: One, recognize the stop Second, the function of stop Basic principles of stop design The method of drawing of the stop design The relationship between the stop and the buckle Sixth, stop and anti-stop relationship Different structures and variations of the anti-stop mouth First, to stop: ? ?? ? The end also has no professional explanation, which can be interpreted literally as the stop structure of the opening, also known as the lip. ? ? The end of the mouth is divided into the male and the female, and the end of the mouth is a lot. Second, the function of stop Why design stops? What is the effect of the end? In general, the main effect of the stop is: 1, the limit. It prevents the housing from being misaligned when it is assembled. As shown here, the end effect is to prevent A shell from forming outwards and prevent the shell from forming inward. 2, anti-static. Seam allowance is also called static wall, can prevent electrostatic from outside to inside, so as to protect the internal electronic components, so as far as possible when the design retains the integrity of the whole circle. Basic principles of stop design Basic principles of stop design: A and the common stop are usually on thin shells. B, the mother tongue is usually made on the shell of thick thickness. In the case of the cell phone, the shell is mostly A thin shell, and the shell is thick. But the important thing to note is that the public stop doesnt have to be in the case of A shell, if the shell is thick and the shell is thin, the end of the mouth is in the shell. C, the size of the stop: Size a is the height of the public stop, the range is 0.60-0.80 The dimension b is the width of the end of the end, which is 0.60-0.80, and the minimum width should not be less than 0.50 The dimensions of c1 and c2 are two to three degrees Size d chamfering size, good assembly, usually 0.25-0.30 D, the match size of the en