灰色靠得住性设计在机械产品优选中的应用(国外英文资料).docVIP

灰色可靠性设计在机械产品优选中的应用(国外英文资料) The meaning of the resolution coefficient The purpose of correlation analysis is to determine the degree of influence of various factors in the system. The grey correlation degree is the basis of the relation space, and the value of the resolving coefficient will affect the calculation result of the correlation degree, which will affect the analysis and decision of the evaluation system. Define {x0 (k)}, {xi (k)}, the initial value sequence of the observation sequence of system factor x0, xi, and k = 1, 2, m, which is: Xi = {xi (k) (k), (k) = 1, 2, m} (I = 1, 2, n). In the calculation of gray correlation analysis Delta Max = x0 (k) -xi (k) (4) Delta min = x0 (k) -xi (k). Delta I (k) = x0 (k) -xi (k). The gray correlation coefficient is: (k) = (5) From the position in type (5), the influence degree of the system factors on the correlation degree is reflected objectively, it is the coefficient of delta Max. The smaller it is, the less important it is for the delta Max. And vice versa. The value of the 3.2 resolution Distinguish the value of coefficient of inevitably in the operation of the system by many uncertain factors, make the observation sequence produces LiLuan information and affect the correlation analysis result, consider these factors when determining value should be comprehensive. # p# page # # # # # When the observed sequence is disturbed by an uncertain factor, it is recorded as xi (p) when the observed value of the delta Max is: Delta Max = x0 (k) -xi (k) = x0 (k) -xi (p), k = p (6) If at p time, xi is very strongly disturbed, and that leads to a big change in the value of delta Max. At this point, the ri value will be determined by the decision of the delta Max, which will be closer to 1. At this point, the correlation sequence is low because of the close correlation degree. According to the above analysis, the system is very strong interference, should take smaller values, in order to weaken the influence of outliers, avoid