点焊机的七大弊病维修(国外英文资料).docVIP

点焊机的七大故障维修(国外英文资料) troubleshooting Step 1, the pedal welding machine is not working, the power indicator is not bright: A. check if the voltage is normal; Check that the control system is normal. Check the contact points, contact contacts, and the contact of the switch. 2, the power indicator is bright, the workpiece is pressed and not welded: A. check whether the pedal stroke is in place, and whether the pedal switch is in good contact. Check that the lever spring screw is adjusted properly. There should be no spatter when welding: A. check if the electrode is oxidized. Check whether the welders are seriously corrosive of corrosion. Check to see if the switch is too high. D. check if the pressure is too small and the welding procedure is correct. 4, the welder is badly dented and has the extrude: A. check if the current is too large. Check whether the welders parts are uneven. C. check if the electrodes are too stressed, and the head shape and section of the electrode are appropriate. Insufficient strength of welder: A. check to see if the electrode is too low, and check if the pole is tight. B. check if the welding energy is too small and the welders parts rust and make the solder contact bad. C. check if there is too much oxide between the electrode and pole, electrode and electrode arm. D. check whether the head section of the electrode is increased by wear and tear. E. check to see if the electrode and copper combination are significantly oxidized. 6, ac contact when welding is abnormal: A. check whether the ac contactor is under voltage 300 volts when welding. B. check if the power lines are too long, causing the line to drop too much. C. check if the network voltage is too low to work properly. D. check whether the main transformer has a short circuit, causing too much current. The welding machine is overheating: A. check the insulation resistance between the electrodes and the body, causing a local short circuit. B. check whether the feed water pressure, wa