环氧浇注高压电子变压器的尽缘设计(国外英文资料).docVIP

环氧浇注高压电子变压器的绝缘设计(国外英文资料) Epoxy pouring voltage electronic transformer insulation design Abstract: in order to improve the insulation performance of high voltage electronic transformer, high voltage transformer appropriate USES heart type, single package structure form, using epoxy resin casting, in practice, the thickness of the casting is 1/3 ~ 1/4 of the theoretical value. At the same time, to avoid the phenomenon of climbing or flying, in good indoor environment, the design of exterior insulation is 400 v/mm. Then through improve the level of pouring process and adjust the curing method to improve the cracking resistance of transformer winding and to reduce the partial discharge, make the transformer insulation performance requirements, the transformer can safe, stable and reliable line operation. Key words: epoxy; Electronic transformer; Insulation design; Partial discharge The introduction Electronic transformer is widely used, it is a very important component of various electronic products, its quality is directly affecting the reliability of electronic equipment. The insulation level of the transformer is the key to guarantee the safe, stable and reliable operation of the transformer, so the insulation design of the transformer is very important. In the insulation design must be combined with transformer application of technical standards, environment, performance index and working state, the insulation of the transformer with different parameters are different structure and the process method, in order to achieve the required insulation performance. How to ensure the insulation performance of transformer to meet the requirement, now do the following analysis. Consideration of the design of insulation design for high voltage electronic transformer 1.1 insulation resistance Mainly check the insulation resistance of the transformer insulation system defects and defect defects, is to verify the transformer insulation in the norm, hot, high temperature and humid