石膏砌块墙体施工计划(国外英文资料).docVIP

石膏砌块墙体施工方案(国外英文资料) Construction plan of gypsum block wall -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- - Xing tai jun and wall materials co., LTD Gypsum masonry wall construction scheme (key points) First, preparation for construction In this project, the wall of the partition is chosen: 666mm times 500mm by mm (long x thick), about square meters. Supplementary materials include: gypsum bonding pulp (raw material), grid band, wood structure etc. Second, the construction operation condition The construction unit shall be responsible for the positioning of the spring-line in the design drawing or the foundation of the gypsum masonry in advance. No water in the construction site, the ground should be swept clean. Water, electrical pipes and other procedures are arranged (water, electricity, fire, etc. Construction units themselves to do their own maintenance). 4, the site has been piled up. 5, operating location environment temperature should be not less than 5 ℃, lower than 5 ℃, the winter construction measures should be taken. Third, construction procedure Ground clean - up and down or so positioning pay-off - map facade blocks - check the cleaning the grassroots, block masonry, the reserved - detection window hole wall roughness, verticality, connected to the main structure. 4, construction points The length of block length is the same as the length of the masonry. The joint length is not less than 1/3 of the length of the block. The mortar seam meets the following rules: (1) horizontal and vertical grey seams shall be flat, vertical, thick and full, not to be false. (2) the thickness and width of the ashes shall be controlled at 7-10mm. (3) the horizontal grey seam shall be paved with slurry, and the mortar shall be full. Vertical grey seam should be covered with a full face method. The bonded pulp meets the following rules: (1) th