离心泵点检标准(国外英文资料).docVIP

离心泵点检标准(国外英文资料) Inspection standards and methods of centrifugal pump Inspection area Check the content Standards and requirements Check the method note pump seat There is no loose or solid ground screw The ground screw is tightened and filled in hammer Is the base level Adjust the level to the level visual al shaft device There is no abnormal sound There is no severe wear and tear on the wheel, no movement of transmission shaft, no abnormal sound. Listening to the sounds The screws are loose No loose screw visual shaft bearing with shaft Set of Is the bearing temperature too hot Sliding bearing temperature 65 ℃; Rolling bearing temperature 70 ℃. The instrument Whether the bearing double peak amplitude exceeds the allowable value Speed 1800 r/min or less, The amplitude of the rolling bearing is 0.0762 mm Sliding bearing amplitude 0.0762 mm Speed: 1801 ~ 4500 r/min The amplitude of the rolling bearing is 0.0508 mm Sliding bearing amplitude 0.0635 mm The instrument The bearing is a phenomenon of bending, fraying, crack and erosion Pump shaft straightness 0.05 mm, Surface roughness 0.8 um The instrument Check if the grinding of the outer ring is too deep The depth of circular ring on the outer ring of the shaft is no more than 0.5 mm The instrument Check to see if the pump shaft is in good condition with the flat key of the impeller and the coupling Flat key of the two sides should be with the side of the keyway on the pump shaft to realize a small amount of interference fit, but with keyway impeller For transition fit on both sides and coupling hole keyway The instrument shaft seal loading buy Check whether the shaft seal is too tight When the equipment is running, the bearing is wet and the equipment is not running, and the water drops from 5 to 20 drops per minute. visual Check whether the radial clearance between the seal ring and the inlet of the impeller is too large or too small Between the sealing ring and the outer circle of the impeller, it should be