第八课 直线的投影(国外英文资料).docVIP

第八课 直线的投影(国外英文资料) The projection of line 8 Learning purpose??? The rule of projection of a students point and line? 2. Enable students to master surface and a plane projection rule of knowledge points and linear projection rule taught to learn to master the content:. Master the content: Illustration method: this is a combination of diagrams. Fang fa: teaching method, practicing law. Class time: 3-2 3-3 courses: The projection of the 3.3 line A projection of a line of position The projection of a line can be determined by the projection of two points of the line. A projection of straight line segment is commonly used in linear projection, which is to make a straight line on the projection of two endpoints, then the two points with the surface projection of the attachment is the projection of straight line segment. According to the straight line in plane system of three plane position, straight line can be divided into general position lines and plane parallel lines and three types of vertical line between planes. The latter two classes are collectively referred to as a special position line. ????? The general position line ????? Since the general position line is tilted at the same time with three projectors, the following projection features are shown in figure 3-11: ????? (1) the three plane projections of the line are tilted to the projection axis, and they do not reflect the Angle of the plane on the projection axis. ????? (2) the length of the line three sides of the projection is shorter than the real long, the projection length is associated with the Angle of straight line on the plane, namely the ab = ABcos alpha, a b = ABcos beta, a b = ABcos gamma. INCLUDEPICTURE /NCourse/jxzt/courseware/chapter3/images/yibanxian.png \ * MERGEFORMATINET, the projection of a straight line in the general position of a straight line, ??? The projector is flat ????? Plane parallel lines, and positive parallel straight line called is flat line, parallel to the horizontal plane