练习须知(国外英文资料).docVIP

实习须知(国外英文资料) (5) foundation The base selection type adopts the independent basis, the base level is -5.10 M The base floor of the steel bar should be the 100 thick layer of the C10, which is 100 on each side of the foundation 3. The thickness of reinforced foundation, there are pad 40, there is no cushion in 70, with direct contact with the outside building waterproof of reinforced soil retaining wall, column in the part of the ground outside protective layer thickness should be increased to 40 outward. (6) ground Formation soil description: the base should be set on the undisturbed pebble bed, the bearing capacity of F = 350KPa The base tank inspection shall be carried out according to the engineering geological survey report and the construction drawing, and the inspection and design personnel shall be required to participate. When the infrastructure is finished, the ground of the gobi, which has an erosion effect on the base, has been refilled in gravel and soil. 4. The foundation excavation should be stipulated in the blasting engineering construction and acceptance standard and put slope, influential to adjacent building foundation pit, should do by has the design and construction of rock units supporting design and construction. (7) preparation for construction Basic work before template installation: 1) pay-off: first putright construction side column, wall axis, flat as a starting point to the axis, which leads to the various axis. Template pay-off, according to the center line of the construction drawing with chalk line pop-up template and sideline, wall template will popup template edges and the lateral line, so that the template installation and calibration. 2) use a level of water level to set the level of the building in accordance with the requirements of the actual elevation, and direct it to the position of the template. 3) the bottom part of the template should be made up in advance and the clutter should be cleaned up to ensure that the template p