网梁结构(国外英文资料).docVIP

网梁结构(国外英文资料) But net thickness of slab-column system generally larger engineering (completed the thickest reached 1200 mm), and the edge beam section height difference is not big, but larger than the beam width is very much, so the side beams of slab-column system support effect is not obvious, net of slab-column system internal force was in large part to the column directly. (computational analysis and measured data confirm this pattern). The net beam and girder are the relations of the coordination of deformation. This is very different from the way the rods are structured. The net beam floor mechanics model is a panel with a continuous box section. But there is a big difference between the bridge and the bridge, and there are two main aspects: The net beam floor is thicker, its thickness is between the beam and the board, close to the scale of the wide flat beam (because of the large cavity, can make thick). The frame of the net beam is covered with an overcast rib, which is different from the slab reinforcement without the frame of the beam. Therefore, the anti-lateral mobility and structural ductility of the net beam floor are much better than the non-girder. Method of calculating the roof of the grid Finite element method According to the structural characteristics and force characteristics of the net beam floor, it is best to design the roof of the grid with the finite element method. The mechanical unit of the net beam floor is a box section. At present, the finite element method is used to calculate the popularization. The mechanical model of finite element software is much closer to the actual structure. The solid parts and hollow parts of the unit can be entered separately. The structure of the mechanical units, such as beams, plates, columns, walls, shells, cables, films and blocks, etc., can be calculated. 3) the division of cells can be very elaborate, and the structure of hundreds of thousands of units using a personal computer is a very simple probl