(甲板)挖泥操作(国外英文资料).docVIP

(甲板)挖泥操作(国外英文资料) Operation procedures for dredging operators The excavators shall strictly observe the rules of this operation: First. The basic rules The dredge operator must be centrally manager and carefully operated during the value period. Check and refueling during the excavated construction period, check the status log. After stopping the dredging, check the dredging equipment such as bridge, winch and steel pile, and check for the log. Maintain effective and timely contact with crew or other personnel on board. Keep an eye on the sea surface and notice the safety of the ship and line. Actively cooperate with the demolition and repair work of the Marine department. Two. The operation of the dredging control platform Observe the indicator value of the production meter, and control the flow rate and concentration according to different conditions. Observe the hydraulic pressure indicator to understand the state of the hydraulic units. If there is any abnormality, the reason should be examined in time. Observe the pressure indicator of the mud pump and pump to understand the pump status. Pay attention to the alarm. In case of alarm, press the accept alarm button first. After reading the contents of the alarm, press the accept click button. The above operation will be repeated for every alarm call, and the engine room personnel will be notified immediately. The action master and the secondary steel pile must wait for the corresponding indicator light (or extinguish) to proceed to the next step. Before the free-fall, the steel pile fixture must be fully open. When two piles are landed, it is absolutely not allowed to swing a dredger. The cable sometimes relaxes when the cable is loose. If the anchor is likely to swing forward, it must relax the cable so that it is greater than the length of the insurance cable. When the windlass is used, the anchor winch must be placed in the free spring position before the windlass is used. The speed control knob of the anchor a