刺墙尺寸设置(国外英文资料).docVIP

刺墙尺寸设置(国外英文资料) Wall size setting (side wall winding simple calculation) The water sluice chamber or the spillway barrier is encountered while retaining water or spillage. Lock chamber or follow spillway weir crest slab, the downstream side of the wall construction joint water is commonly used in seepage prevention treatment, if you can ensure no water flow from the construction joint and generally do not have to set up the wall, but the contractor if jerry, seepage of water stop material short of asks, then stab need to consider setting up a wall. The barbed wall usually takes the width of 0.3 ~ 0.4 m, and the length needs to be decided. According to the water lock, which is compiled by Chen baohua, the method of resistance coefficient is calculated. Here is a simple calculation of the wall of a spillway. To check flood level condition to calculate (at this point, the downstream water level difference maximum), upstream reservoir 5 a once-in-a-century check flood level of 64.18 m, floor height of 58.2 m, spillway flow width of 13 m, through the trial, bottom downstream water depth of 60.50 m, and downstream water level difference as = 64.18-60.50 = 64.18 m. According to the introduction of the water lock, the length of the thorn wall can be 1 ~ 3 times, the lower water level difference, combined with the size of the proposed bridge, the length of the wall is 4 meters, and the detailed layout is shown in figure 1. The bridge is 14.14 m and the tooth wall is set in the middle of the bridge. According to the floodgates, the side of the bridge is about half the length of the bridge, about 7.1 m (see figure 2). Because the wall is thinner (0.3 m wide), it can be reduced to the short plate pile calculation. The resistance coefficient of each section is carried out in accordance with the water brake design specification (SL265-2001). The screenshots are as follows: Import and export section: Internal vertical segments: Internal level: Figure 1 bridge and barbed wall arran