浓度新标准200701(国外英文资料).docVIP

浓度新标准200701(国外英文资料) Two, must use legal measure unit Documents such as the national hair [1984] no. 28, etc., have already requested that the articles be used by legal units. Please execute them seriously. For the use of legal units in our country, please refer to the national standard GB 2586-91. GB 3100-3100-3102. Some commonly used statutory units of international notation are the length of nanometers, mu m, mm, cm, m, km (no mile, yd, etc.). The mass is mu g, mg, g, kg, t (not lb, qr, oz, etc.); Force N (no KGF, tf, dyn, etc.); Pressure using Pa (no ATM, mmHg, mmH2O, etc.) J (no Cal, erg, etc.) Power W (no HP, etc.); Time USES s, min, h, d, and a; Moles of matter (not molecules, etc.); The concentration of matter is in moles per liter, mol/m3, not molecule concentration, N, PPM, PPB, etc. In combination units, you should also note that r/min replaces RPM. The international symbol of the unit of measurement should be used boldly. The definition and expression of the quality score, concentration and mass concentration of the chemical substances are as follows: The mass ratio between A and B should be expressed as: m (A) : m (B) = 2:1 [A: B = 2:1 is false]; The volume ratio of the chemical substance should be expressed as V (A) : V (B) = 2:1; The ratio of the amount of chemical to the ratio of the ratio of the particles to the ratio of the particles to the ratio of the particles to the ratio of the particles to the ratio of the particles to the ratio of the particles should be expressed as n (A) : n (B) = 2:1; The A and B in brackets shall be the names of the chemical or the molecular formula. The mass fraction of chemical A should be expressed as w (A) = 20% (A = 20% is wrong); The volume fraction of the chemical should be expressed as: phi (A) = 20%; The mole fraction of the chemical should be expressed as x (A) = 20%. Its important to note that only the amount of material concentration is called the concentration, and the units are moles per liter, which can be