球型止回阀(国外英文资料).docVIP

球型止回阀(国外英文资料) The changsha multi-stage pump manufacturer hongli pump industry is organized in Ball check valves Micro wear resistance without a ball check valve USES the rubber ball sealing structure design, with rubber bag the ball for the disc, in under the action of medium, can be in the body on the slideway of the scroll, and open or close the valve. The non-wear ball check valve has the traffic flow resistance loss small, the sealing performance is good, the noise is low, the noise is closed, can reduce the water shock wave, the service life long and so on characteristic. Horizontal or vertical installation can be widely applied in water pump outlet of cold water, hot water, industry and domestic sewage, so as to prevent the flow of medium. Microblocking ball check valves mainly have two products: HQ44X, HQ45X Ball check valves Ball check valve principle: The disc of ball check valve is a ball of rubber or engineering plastic, so its sealing performance is reliable. Ball check valves have a single ball and multiple balls based on the size of its nominal size. The sealing principle is: when open pump, the medium pressure caused by the medium flows forward drive ball movement, along the guide pin to leave the seat sealing surface, the check valve is open, medium through; Reverse flow when the pump stop, medium pressure push sphere to the valve seat sealing surface along the guide pillar, closed check valve, the pressure of the working medium, make the ball produce certain between disc and seat sealing surface sealing pressure, to ensure that the check valve sealing, reach the purpose of preventing medium counter-current. Because ball valve disc and seat airtight cover contact is narrow, close to the line seal, so as long as the ball is round, it is easy to seal. Because of the narrow cover, under the same pressure of the same medium, the sealing of the line seal is greater than the seal of the seal, so the sealing is reliable. But the ball check valve seal sphe