思科IPS 密码恢复文档.pdf

Password Recovery Procedure for the ASA Security Services Modules AIP−SSM and CSC−SSM Document ID: 82109 Contents Introduction Prerequisites Requirements Related Products Conventions Step−by−Step Procedure Sample Procedure Related Information Introduction This document describes how to recover a password on a Cisco ASA 5500 Series Content Security and Control Security Services Module (CSC−SSM) or the Advanced Inspection and Prevention Security Services Module (AIP−SSM) without the need to re−image the device. Prerequisites Requirements A list of additional files that you need for the recovery procedure is required. This includes an explanation of how and where to get the files and any processing that needs to happen before the recovery procedure begins. Cisco ASA 8.x and later software provides a mechanism to reset the passwords of the SSM modules (CSC or AIP) without the need to re−image the device. Note: The CSC and AIP modules must run version 6.0 in order for the feature to work. There is no option for password recovery in version 5.0 for the AIP−SSM or CSC−SSM, because this feature is not introduced until version 6.0. Related Products This password recovery procedure can be used for any of these products: • Advanced Inspection and Prevention Security Services Module (AIP−SSM) • Content Security and Control Security Services Module (CSC−SSM) Conventions Refer to Cisco Technical Tips Conventions for more information on document conventions. Step−by−Step Procedure This step is necessary in order to complete the password recovery. Issue the hw−module module module_num password−reset command from the Cisco ASA CLI. For the AIP module, this command sets the configuration register in ROMMON to cause a boot of the password reset image and then power cycles the module. For the CSC module, this command sends the session 1 do reset−password command to the module. ciscoasa(config)#hw−module module 1