220m钢筋混凝土烟囱筒身方案(中-英).docVIP

1、控制规范CONTROLLING SPECIFICATION 1.1客户规范Client’s Specification. 1.2合同文件Contract Document 1.3设计施工图纸Design Drawings 《220米烟囱外筒结构》施工图册F151S-T0315，《220米烟囱内筒、内部钢平台及屋面》施工图册F151S-T0316，《220米烟囱钢梯》施工图册F151S-T0317 F151S-T0315：Structure of Exterior Shell for 220m Chimney F151S-T0316：Inner Steel Flue、Interior Steel Platform and Roof of 220m ChimneyF151S-T0317： Steel Ladder of 220m Chimney 2、工程概况 General introduction 2.1工程概况 General introduction ±0米高程相当于绝对标高377.50米。烟囱外筒为钢筋混凝土结构，高度为216m。筒壁±0.00m直径为20.00m，出口▽216.00m直径为11.00m。外筒▽60.0m以下筒壁外半径随高度的增加按4%的坡度减少，壁厚在700㎜～600㎜；外筒▽60.0m～▽160.0m筒壁外半径随高度的增加按2%的坡度减少， 壁厚在550㎜～400㎜；▽160.0m以上外筒壁为直段，壁厚在350㎜～300㎜。 Relative height ±0.00m of chimney corresponds with absolute elevation 377.50m. The exterior shell of the chimney is RCC structure with the height of 216m. The diameter of ±0.00m of the shell is 20.00m,and the diameter of the exit at the height of 216m is 11.00m. The outer radius of the shell below the height of 60.0m will be decreased by 4%of the grade of slope with the increase of the height and the thickness of shell here is between 700mm to 600mm, while, the outer radius of the shell wall at the height between 60m to 160m will be decreased by 2% of the slope degree with the increase of the height and the thickness of shell here is between 550mm to 400mm. Above the height of 160m shell is straight, and the thickness of shell is between 350mm to 300mm.. 2.2主要工作量Main quantity 砼Concrete M35：4906m3 钢 筋Rebar：580t 钢结构Steel structure：160t 航空色标Aviation mark：5830m2 3、资源配置Resource arrangement 3.1劳动力组织 Labor Arrangement 劳动力安排计划表Labor Arrangement Schedule 序号NO. 工 种 Type of work 人数Amount 备 注 Remarks 1 木工carpenter 24 模板安装、拆除等Shuttering erection and removal 2 钢筋工 Rebar erection worker 12 绑扎钢筋 Rebar erection 3 砼工 concreting worker 4 浇筑混凝土Concreting 4 瓦工Masons 2 收面，施工缝处理 Finishing and treating construction joint 5 机械操作工Mechanician 8 机械操作、维修 Repairing and operating machines 6 电工electricians 2 电气安装维修 Electric installation and repairing 7 焊