根据不同桩长对比试验优化设计桩持力层的研究_张忠苗.pdf

26 2 Vol.26 Supp.2 2007 12 Chinese Journal of Rock Mechanics and Engineering Dec. 2007 ( 310027) 8 55 m 13 88 m8 20 m TU 41 A 1000 6915(2007)2 4251 07 STUDY ON OPTIMIZATION DESIGN OF PILE BEARING LAYER ACCORDING TO CONTRASTIVE TESTS WITH DIFFERENT PILE LENGTHS ZHANG Zhongmiao YU Jun ZHANG Guangxing (Institute of Geotechnical Engineering Zhejiang University Hangzhou Zhejiang310027China) Abstract The behaviors of bearing capacity and settlement of bored piles in two different depth bearing layers with/without end post-grouting are studied contrastively through static load tests for piles with different lengths in a certain engineering practice of Ningbo City. The study results show that if the 8th soil stratum—silty soil is selected as bearing layerthe pile length is 55 m and employing pile end post-grouting can increase the bearing capability and decrease the pile top settlement remarkably although selecting the 13th soil stratum—sandy gravel embedded with clay as bearing layerwhere there is bedrock below it can prevent pile end from plunge failure effectively. Therefore the pile length is 88 m and it is very difficult to penetrate the silty sand stratum during installationwhich is about 20 m in thickness. Therefore the construction quality is hard to control. This makes mudcakes around piles at pile ends too thick resulting in decreasing of the bearing capability of single pile and failure to meet design requirements. The technical economic analysis is made quantitatively and the selection of pile bearing layer is optimized. In order to guarantee the safety of engineering piles it