三相异步电机正反转+能耗制动程序.docVIP

附录 主程序： #include reg51.h #includelcd.h #include intrins.h sbit K1 = P1^0; //对应按钮K1 sbit K2 = P1^1; //对应按钮K2 sbit P20 = P2^0; sbit P21 = P2^1; sbit P22 = P2^2; //分别控制三个继电器工作 #define GPIO_LED P3 //led使用P3口 //--定义全局函数--// void Delay10ms(unsigned int c); //延时10ms unsigned char Key_Scan(); //--定义全局变量--// unsigned char PuZh[]=status: foreward; //正转 unsigned char PuZh2[]=status:inversion; //反转 unsigned char PuZh4[]= energy transit ; //能耗 unsigned char PuZh3[]= ; //显示空行 void main(void) { unsigned char ledValue, keyNum,i; LcdInit(); //初始化显示屏 P3 = 0x00; //灯全灭 P20=0XFF; P21=0XFF; P22=0XFF; //三个继电器都断开 while(1) { keyNum = Key_Scan(); //扫描键盘 if(keyNum==1) { do { for(i=0;i16;i++) { LcdWriteCom(0x80+i); LcdWriteData(PuZh[i]); LcdWriteCom(0x80+0X40+i); LcdWriteData(PuZh3[i]); } //lcd显示正转 ledValue = 0x01; GPIO_LED = ledValue; P20=0X00; //继电器吸和打开 P21=0XFF; P22=0XFF; Delay10ms(500); //正转10秒 keyNum = Key_Scan(); //扫描键盘 for(i=0;i16;i++) { LcdWriteCom(0x80+0X40+i); LcdWriteData(PuZh4[i]); LcdWriteCom(0x80+i); LcdWriteData(PuZh3[i]); } //lcd显示能耗 ledValue = 0x02; GPIO_LED = ledValue; P20=0XFF; P21=0X00; P22=0XFF; Delay10ms(50); //能耗1秒 keyNum = Key_Scan(); //扫描键盘 for(i=0;i16;i++) { LcdWriteCom(0x80+0X40+i); LcdWriteData(PuZh2[i]); LcdWriteCom(0x80+i); LcdWriteData(PuZh3[i]); } //lcd显示反转 ledValue = 0x04; GPIO_LED = ledValue; P20=0XFF; P21=0XFF; P22=0X00; Delay10ms(500); //反转10秒 keyNum = Key_Scan(); //扫描键盘 for(i=0;i16;i++) { LcdWriteCom(0x80+0X40+i); LcdWriteData(PuZh4[i]); LcdWriteCom(0x80+i); LcdWriteData(PuZh3[i]); } //lcd显示能耗