基于流变学的初生固相定量表征.pdfVIP

2010 15 1 54 CH NI ESE JOURNA L O F STEREOLOGY AND MI AGE ANALYS SI Vo.l 15 No. 1 March 2010 : 100 - 1482 ( 2010) 01- 0054- 05 1 1 2 , , ( 1 , 100044; 2. , 315100) : 根据初生固相的形貌尺寸和数量对半固态合金熔体流变性能的影响作用, 提出 对半固 态合金熔体初生固相的定量表征方法该方法首先对初生固相颗粒边界进行平滑处理对聚集或 粘连在 一起的初生固相颗粒进行分离以及根据设定的阈值筛选并剔除取样过程形成的小颗粒, 然 后再利用图像分析软件统计计算半固态合金熔体中初生固相的体积分数尺寸大小和圆整度等微 观结构参量利用这一方法得到的半固态合金熔体中初生固相的特征参数为半固态合金熔体的微 观流变学研究提供 可靠的数据 : 半固态熔体; 定量金相; 流变学 : TG 11521 : A Quan titative m etallograph ic analy sis for the solid phase in a sem isolid alloy m elt based on the rheology 1 1 2 XING Shuming, BAO Pewi ei, LI Wen ( 1. Bejing Jiaotong niversity, Bejing 100044, China; 2. Ningbo Institute ofTechnoIogy, Zhejiang niversjty, N ingbo 315100, China) Abs tract: According to the effects of solid phase on the rheology of the sem isolid alloym el,t anew meth od is presented to calculate the characteristic parameters of the solid phase in a sem isolidmelt. There are two steps in themethod. The first step is tomodify the solid figure such as smoothing theboundary of the solid grain, separating the coalescent grains, and elmi inating the small grain formed in the sampling process. The second step is to calculate them icrostructure param eters such as average diameter, volume fraction and the shape coefficient of the solid grains. To obtain theseparameters are very mi portant to ex plore them icrorheology of the sem isolid alloy. K ey w ord s: quantitativemetallographic analysis; sem