叉杆加工工艺及钻M8孔夹具设计【毕业论文+CAD图纸全套】.doc

镇 江 高 专 ZHENJIANG COLLEGE 毕 业 设 计 (论 文) 叉杆加工工艺和夹具设计 Fork lever processing technology and fixture design 系 名： （四号宋体） 专业班级： （四号宋体） 学生姓名： （四号宋体） 学 号： （四号宋体） 指导教师姓名： （四号宋体） 指导教师职称： （四号宋体） 年 月 摘 要 叉杆零件的加工工艺规程及的专用夹具设计。 关键词：叉杆类零件；工艺；夹具 Abstract This design is the special fixture for machining technology for the chemical pipeline parts and process design based on. The main processing surface chemical pipeline parts is the plane and a series of hole. In general, ensure the machining accuracy of plane than to ensure the accuracy of the processing easily. Therefore, the design follows the surface after the first hole principle. And the hole and the plane processing clearly divided into roughing and finishing stages to ensure machining precision. The main process of machining technology is first to support hole positioning processing the top plane, and then the top plane and the series of supporting hole location hole processing technology. In addition to the follow-up processes are individual processes with the top plane positioning technology and other processing Kong and plane. Processing support holes using the coordinate boring. The whole process selection of general. The special fixture fixture, clamping means more choice of pneumatic clamping, clamping reliable, agencies can not self-locking, therefore the production efficiency is high, suitable for large batch, line processing, can meet the design requirements. Keywords: chemical pipe parts; technology; fixture 目录 摘 要 I Abstract II 第1章 机械加工工艺规程设计 1 1.1 零件的分析 1 1.1.1 零件的作用 1 1.1.2 零件的工艺分析 1 1.2 叉杆加工的主要问题和工艺过程设计所应采取的相应措施 2 1.3 叉杆加工定位基准的选择 2 1.3.1 粗基准的选择 2 1.3.2 精基准的选择 2 1.4 叉杆加工主要工序安排 2 1.5 机械加工余量、工序尺寸及毛坯尺寸的确定 4 1.6 选择加工设备和工艺装备 5 1.6.1 机床选用 5 1.6.2 选择刀具 5 1.6.3 选择量具 6 1.7 机械加工余量、工序尺寸及毛坯尺寸的确定 6 1.8确定切削用量及基本工时（机动时间） 6 第2章 钻M8孔夹具设计 12 2.1研究原始质料 12 2.2定位基准的选择 12 2.3 切削力及夹紧力的计算 12 2.4误差分析与计算 13 2.5 零、部件的设计与选用