帝思 机头控制器.pdf

M: 72x144mm XC700/800/900M • The XC700/800/900M series are designed for application involving the control and management of compressors and fans in compressor racks • Management of compressor racks with up to 9 compressors and 6 fans (max 11 loads) • Proportional band or dead band control • Load activation: in set sequence or with automatic rotation • Delay times and safeties setting • Temperature and pressure display depending of the gas (also for ammonia) • Reduced set point for energy saving management • Alarm input management: for each load, high and low pressure switch, liquid level • Operating data recording: pressure and loads • Last 10 alarms recording: kind of alarm, date and time for service calling • Graph and operating data printing via infrared, together with parameters and alarms (XC900M) • Built in run time meters for each stage + “maintenance due” signal • Standard communication protocol ModBUS-RTU • Hot key or Prog tool kit connector for a quick and easy programming • 12VA max power absorption • Dual display with red LED (13,2mm high), green LED (13,2mm high) • Standard compressor protection • Type of refrigerant: R22, R134A, R404A, R507, R717 (other available) • Resolution: 1/100 bar for suction , 1/10 bar for condensing XCM X C M - A B 0 D E A B D E Power supply Input Measurement unit Extended memory for infrared 2 = 24Vac A = Suction PP07; condensing PP30 1 = Bar - °C 0 = No 4 = 110Vac B = Suction PP07; condensing NTC 2 = PSI - °F 1 = Yes 5 = 230Vac C = Suction NTC; conde