1NE40E-8 快速安装指南课件.pdf

Precautions 注意事项 This document aims to provide simple and distinctive guidelines for hardware installation. For details on the cabinet installation operation steps, refer to the Cabinet Installation Guide along with the equipment. This document does not describe operations for the pre-delivery installation. Instead, this document describers only the operations for on-site installation. 本文档用于为设备硬件安装提供简明快捷的操作指导，如需参考机柜的安装操作步骤，请参阅随设备发货的 《机 柜安装指南》。本文档对于出厂前已完成的安装操作不进行介绍，仅对现场安装涉及的操作进行介绍。 Electrostatic Discharge 静电 Before touching the device, boards and IC chips, wear the ESD wrist strap to prevent the electrostatic discharge of the human body from damaging the sensitive components. Ensure that the other end of the anti-static wrist strap is well grounded. 在接触设备、单板、IC 芯片等之前，为防止人体静电损坏敏感元器件，必须佩戴防静电手腕，并将防静电手腕 的另一端良好接地。 Bundling cables 绑扎线缆 l The distance between cable ties or fiber binding straps inside the cabinet should be within 200 mm. 在机柜内部，线扣/光纤绑扎带的绑扎间隔不超过200mm 。 l The distance between cable ties for all cables and corrugated pipes outside the cabinet is determined according to the distance between two horizontal beams. For the cabling trough without beams, bundle the cables with the distance not exceeding 250 mm between cable ties. 在机柜外部，所有线缆和波纹管的线扣绑扎距离以两横梁之间的间距为准，没有横梁的走线槽按照不超过 250mm 的间距绑扎。 Affixing labels / tags 粘贴标签/ 标识牌 Affix the label or tag to the signal cable, 20 mm away from the connector. When the cable is placed vertically, the label or tag should point towards the right. When the cable is placed horizontally, the label or tag should point downwards. 标签/标识牌默认粘贴位置在距离连接器20mm 处，标签/标识牌在电缆上粘贴后长条形文字区域一律朝向右侧或 下侧。即：当电缆垂直布放时标签/标识牌朝向右；当电缆水平布放时标签/标识牌朝向下。 For details on the printing labels, refer to the Installation Guide delivered in the form of CD-ROM along with the equipment. 标签的制作方法请参阅随设备发货的光盘中的《安装指南》。 1 Installation Preparations 安装准备 Tools 工具