ansys命令流----前后处理和求解常用命令之求解与后处理(国外英文资料).docVIP

ansys命令流----前后处理和求解常用命令之求解与后处理 Ansys command stream - before and after treatment and solving and post-processing of solving common commands. TXT fox is a mountain, you tell me what the serial, standing in your nearest place, looking you smile to others, even if the heart is every pain for your every move. Dazzling white, let me understand what is pure damage. 3 / solu U/solu goes to the solver 3.1 plus boundary conditions U D, node, lab, value, value2, nend, ninc, lab2, lab3,... Lab6 defines the node shift constraint Node: the Node number of the pre-additive displacement constraint, if all the selected nodes are fully constrained, the nend and ninc are ignored. Lab: ux, uy, uz, rotx, rotz, all Value, value2: the number of degrees of freedom (default is 0) Nend, ninc. : node - Nend, no. Ninc Lab2-lab6: lab2-lab6 is applied to the selected node by the same number. Note: discuss in node coordinates Set the solution options U antype, status, ldstep, substep, action Antype: static or 1 static analysis Buckle or 2 buckling analysis Modal or 3 modal analysis Trans or 4 transient analysis Status: new reanalysis (the default), which will be ignored later Rest reanalysis, only static, full transion works Ldstep: specifies which load step to start with, by default the largest, runn number (the last step in the analysis point) Substep: specify which step to start with. The default is the highest number of substeps in the runn file for this directory Action, continue: continue to analyze the specified ldstep, substep Note: there are two types of analysis (interrupted for some reason) Singleframe restart: continue from the stop point Required file: jobname.db must be saved immediately after the initial solution The jobname.emat unit matrix Jobname.esav or.osav: if.esav is broken, it will be.esav Results file: not necessary, but if there is, the result of the subsequent analysis will append well to it Note: if the initial analysis is generated, RDB,.ldhi, or RNNN files. The subseq