CAD试卷(国外英文资料).docVIP

CAD试卷 What are the commands for making parallel lines for a straight line in CAD A. mobile B. the mirror C. the offset D. rotation [2] which command in CAD is used to draw the complex of a straight line and a circular arc A. arc B. tectonic line C. many section of the line Spline curve [3] how do you type 80 in the picture A. % % P80 B. % % C80 C. % % D80 D. % % U80 [4] if you want to mark all dimensions of the figure as twice as large as the original size, you should set the following Text height Use a global scale C. measure the unit proportion Conversion unit [5] which of the following relative coordinates is the line length of 8 units? A. 8.0 B. @ 0, 8 C. @ 0 8 D. [6] which coordinate input method needs to be signed? A. polar coordinates Absolute coordinates Relative coordinates D. [7] which of the following commands can shatter the block to generate a graphical file A. save as Decomposition of B. C. rebirth into D. insert block [8] which option can be used to change the width of the line when drawing multiple lines? A. the width B. the direction Radius of C. The length of the d. [9] the starting point of the line is (10, 10), and if you want to draw a line of 60 degrees in the X-axis, you should enter the line segment with a length of 100 @100 60 B. @ 100 100 60 C. D. 50,86.6 [10] pruning orders (TRIM) can TRIM a lot of objects, but which of the following cannot be pruned A. Arc, circle, elliptic arc B. a straight line Multiline (MLINE) D. rays, construction lines, and spline curves [11] the actual length of the oblique line should be chosen Linear notation alignment Quick note baseline [12] each of the following options can draw a circular arc, except which one is not? The beginning, the center, the end The beginning, the center, the direction C. Center, origin, length D. start, finish, radius [13] in the layer manager, the actions that affect the layer display are available Lock layer New layer Delete layer Freeze layer [14] use the text tool in CAD input