周期性位置更新详解（国外英文资料）.docVIP

周期性位置更新详解（国外英文资料） When the phone is turned off, it will save the current location. When it is turned on, it will check to see if it is in another location, and if it changes, it will be updated The effect is the regular roll-call in the army, and the T3212 timer is set in a periodic update interval In the idle state, the phone first reselected, reselected to the target area and found that the LAC of its own is not consistent with the LAC of the network, so launch the position update. Every mobile phone card has a LAC, is to identify the network location area, MSC in a VLR (visit location register), record all the information of the local users in VLR, if MSC VLR no interpretation of LAC in the news number, the phone is in roaming. Location updates are a proprietary process that is done in the IDLE state of the phone. During the update period, the phone is unable to communicate There is no update on the phone, no call when the location is updated, but the time is very short, and the effect on the connection is very small Why introduce periodic location update When you develop any of the following, the Internet and mobile platform tends to lose contact: the first is that if when mobile open machine and move to the outside network coverage (blind), at this time due to the mobile station cannot be made instructions to the network, so network unable to know the status of the mobile station at present, but will still think the mobile station is still in the state of adhesion; The second case is when the mobile station in send IMSI separation to the network news, if the wireless route of uplink interference with lead to link quality is very poor, so the network can not decode the message correctly, this means that the system still think MS is in a state of adhesion; The third is that when the mobile phone loses power, it also fails to notify the network of its status, causing the two to lose contact. When this happens, if the mobile station is paging at this time, the sys