S与M型等电位连接(国外英文资料).doc

S与M型等电位连接(国外英文资料) Discussion on equipotential bonding technique of type S and M in information system Source: Author: Sun Danbo Zhao Lianyi | | published: 2008-11-13 15:08:17 | browsing: 1125 []: small fonts This paper in the TN - s and TN - C - s grounding type, information system should adopt s type equipotential connection, and to do the three-phase electricity balance, reduce the zero drift voltage, which is not appropriate to take M equipotential bonding measures. Only in the 1Tr and IT power supply systems can the information system be used either s or M equipotential bonding. Keywords s type equipotential bonding; M type equipotential bonding; drift voltage; Equipotential bonding technology has been introduced into a series of new mandatory GB, which plays a positive role in promoting the development of Chinas electrical technology and ensuring the safety of state property and peoples lives. The author in recent years a large number of lightning protection engineering information room practice, summing up the new view of the domestic and foreign experts, have some shallow understanding of equal potential connection technology, hope to discuss with the engineering and technical personnel. 1 reasons for interference of information equipment A stable reference reference potential must be provided in the normal operation of the information equipment. There are two kinds of interference in information equipment, one is low frequency interference, the other two is high-frequency interference. Low frequency interference is mainly caused by common impedance coupling. Because of the different grounding point of each device, the current in the earth wire flows through, causing the potential of each device to be different, thus forming interference. For detailed analysis, see figure 1. In Figure 1, as the low frequency current flows in the ground plane, there is a potential difference between the point A, B and C of the device, which interferes with the information dev