简单手势唤醒便携设备的设计方案(国外英文资料).docVIP

简单手势唤醒便携设备的设计方案(国外英文资料) Simple gesture wake up design for portable devices Introduction: This article discusses how to wake up touch control devices such as tablet computers without contacting devices, but uses basic hand gesture recognition and novel proximity detection sensors. The physical layout, speed limit, detection threshold, system integration and the influence of human factors are discussed in this paper. The software real-time routine is given. A sudden whim in the kitchen If youre using a touch control device for cooking, you may notice that cooking is not as simple as the list of recipes listed in the device. Master Technology (for example I) into the kitchen, love watching tablet computer or smart mobile phone on cooking recipes. You might say, well, how difficult is it? Since the screen is always open will consume a lot of power, usually handheld devices in 1 or 2 minutes after no operation, will automatically enter the sleep state. Then, when you need to refer to the recipe, the device is asleep. In this case, you face two choices: either force the screen to remain permanently open or leave a greasy spot on the screen either with a food - laden hand opener. Of course, you can clean your hands every time you look at them, but its tedious and expensive to wash your hands and dry them repeatedly. I often ask myself, how can I not make the screen open all the time without soiling the device? In fact, there is a way to kill two birds with one stone, that is, a gesture (without touching the screen) to turn on the screen. It sounds complicated, doesnt it? Fortunately, it may be easier to do than it sounds. Proximity detection sensor (sensor data, click E) Many touch screen devices, especially smartphones, have been installed with an infrared (IR) proximity sensor. These sensors automatically switch on / off the screen during the call to avoid accidentally operating the phones input interface. This sensor technology, coupled with smart software design, enabl