注塑件试验规范(国外英文资料).docVIP

注塑件试验规范(国外英文资料) Huizhou training net Test specification of injection molding One. Surface spray (such as shell, backcase, battery shell, etc.) test standard: project tool Test method for Environmental conditions Acceptance criteria Surface adhesion test American knife and 3M adhesive tape Cross over 100 small grids (1 * 1mm) on the surface of the ink and glue the 3M 600 adhesive tape to the test site, then quickly peel off the surface with a force perpendicular to the surface. The normal temperature The test area paint shall not be over 7%. Surface hardness test Friction tester, 2H pencil The surface is not allowed to be scratched. The bottom of the pen is acceptable. The normal temperature The paint layer cannot outcrop the one An alcohol-resistance test 99% industrial alcohol, cotton After rubbing 99% of the industrial alcohol with cotton cloth, the 500g force will be wiped 50 times, the stroke 30mm, the surface color should not be changed obviously. The normal temperature There is no stain on the surface of the cotton cloth. The printed word adhesion experiment 3 m adhesive tape Paste the 3M tape in a silk-print position, apply it five times with an eraser, and then quickly peel off with a force perpendicular to the surface. The normal temperature There is no obvious pen and ink, and the font can be legible. Surface abrasion test RCA abrasion tester With 175g force, the mill is not allowed to grind 100 times; The laptop USES 175g force, and the mill is not allowed to grind for 30 times. The normal temperature The surface is worn and the dew bottom 6, the temperature test High and low temperature box Low temperature (storage temperature: - 40 ℃, time: 8 h) High temperature (storage temperature: 65 ℃, time: 8 h) Temperature shock (mobile phones in high temperature - 30 ℃ low temperature storage temperature and storage temperature 65 ℃ placed 4 h, intermediate conversion time not more than 5 min.) Do not allow the phenomenon such as material fracture, paint crack T