RSLogix_5000_仿真软件使用方法.doc

A Quick Tutorial on RSLogix Emulator 5000 RSLogix Emulator 5000 is a software simulator for the Allen Bradley line of Logix 5000 controllers (ControlLogix?, CompactLogix?, FlexLogix?, SoftLogix5800? and DriveLogix?).?? The goal is to mimic the function of a PLC without the actual hardware and thus do advanced debugging.? More information can be found in the AB publication LGEM5K-GR015A-EN-P. As a quick introduction we’ll go through a simple example of setting up a simulation.? This involves three major steps. Setting up the chassis monitor. 建立机架 Creating a connection in RSLinx. 在RSlinx建立连接 Creating a project with associated emulation hardware. 创建带虚拟控制器的项目 Setting up the Chassis Monitor To start the Chassis Monitor, click Start Programs Rockwell Software RSLogixEmulate 5000 RSLogix Emulate 5000 Chassis Monitor.? When the emulator opens up you’re confronted with what looks like an empty chassis.? In slot 0 is an RSLinx module which has to be there for the emulator communications to work.? Your slot 1 might have another irremovable RSLinx module depending if you are running RSLogix Enterprise. From here we set up our hardware configuration for simulation.? Our first step will be to add the CPU.? In this case it is a special one called an Emulation Controller. Click Slot Create Module. Choose the Emulator RSLogix Emulate 5000 Controller. Chose slot 2 for the controller Click OK to add it to the chassis monitor. At this point you may be accosted with a message about previous configurations.? Just select Reset the Configuration to Default Values and click NEXT. The next two dialog screens are for setting up the controller details.? Click NEXT and FINISH to accept all the defaults. Next we’ll add some input/output simulation. Click Slot Create Module. Choose the 1789-SIM 32 Point Input/Output Simulator. Chose slot 3 for the simulator and click OK. Accept the defaults for the setup by clicking NEXT and FINISH. The chassis monitor will now have two emulation mo