linux系统挂载U盘的方法(国外英语资料).docVIP

linux系统挂载U盘的方法(国外英语资料) Method for mounting U disk of Linux system Hang u before running the command cat /proc/partitions, now take a look at the system in which the partition. After inserting the U disk, running the above command again, look at what partitions (usually sda1, PS because I was on a virtual machine download, so is sdb1). 1, insert the U disk 2, enter fdisk -l /dev/sda to see the output results, such as mine is like this: # fdisk -l /dev/sda Disk /dev/sda: 131 MB, 131104768 bytes 3 heads, 32 sectors/track, 2667 cylinders Units = cylinders, of 96 * 512 = 49152 bytes Device, Boot, Start, End, Blocks, Id, System /dev/sdb1 * 126681280166 FAT16 3, look at the above output, you know the U disk device, such as my /dev/sdb1 is, and then it is mounted, assuming I put the U disk mounted to the /mnt/usb directory (no, new), that is Mount, -t, MSDOS, /dev/sdb1, /mnt/usb If it is FAT16, use the following command Mount, -t, MSDOS, /dev/sdb1, /mnt/usb If its FAT32 Mount, -t, VFAT, /dev/sdb1, /mnt/usb If it is in ext2 format, use the command: Mount, -t, ext2, /dev/sda1, /mnt/usb 4, open /mnt/usb, you can see your U disk in the things! CD /mnt/usb Specific command: 1. plus FAT32 file system The simplest usage Mount /dev/hda6 /mnt/d /dev/hda6 is the authors D disk, and /mnt/d is the directory plus Windows. Linux recognizes the file system type of the /dev/hda6 partition, and then hangs it. Of course, you can specify the file system type of the partition, as follows: Mount, -t, VFAT, /dev/hda6, /mnt/d In practice, a partition of windows is added directly, and the Chinese file name and directory name will appear garbled. In order to avoid this situation, you can specify a character set, and the commands are as follows: Mount, /dev/hda6, /mnt/d, -o, codepage=936, iocharset=cp936 Mount, -t, VFAT, /dev/hda6, /mnt/d, -o, codepage=936, iocharset=cp936 Note: cp936 means simplified Chinese, and cp950 means traditional chinese. 2. plus NTFS file system In most current versions of