2015电工复审培训试题(国外英语资料).docVIP

2015电工复审培训试题(国外英语资料) 1. Grounding wire shall be welded. If lap welding is adopted, the lap length must be 6 times of the diameter of round steel. 2. Grounding wire shall be welded. If lap welding is adopted, the lap length must be 2 times of the width of flat steel. 3 when using a ladder, the angle between the ladder and the ground should be 60 [65]. 4, in the high temperature environment for electrical equipment overhaul, [should avoid as far as possible in the live electricity] homework. 5. The earthing core of the cable of the low-voltage power equipment or the earthing core wire of the multi-core conductor wrapped with the phase line in the same protective shell, the smallest copper core cross section is [1] mm2. 6, electrical equipment fire, the usual prohibition of fire extinguishing equipment is [foam extinguisher]. 7, the main reason for the death of an electric shock is that the current is caused by the physiological reaction of the tissue in the human body. 8, according to the national standard GB3805-83, the upper limit of the series of safety voltage refers to two conductors, or between any conductor and the earth, shall not exceed the effective value of AC [50] volts. 9, general residential buildings, office space, if the main purpose of preventing electric shock, the use of leakage current action for [30] Ma leakage protector. 10 、 the power cord of mobile power tools and switch board (box) must adopt copper core rubber sheath soft cable or copper core PVC insulated sheath flexible cord. 11. If the installation height of the charging meter is arranged in the arrangement of two rows, the vertical distance of the bottom of the upper table case of the meter shall not exceed 2.1 meters. 12. Fuses are used as protective devices for overload and short circuits on the lighting circuit. 13. A three-phase four wire lighting circuit supplied to a gas discharge lamp. Its zero cross section shall be chosen at 100% of the line current [cross sectional rated current