linux_LVM挂载(国外英语资料).docVIP

linux_LVM挂载(国外英语资料) In general, the process of mounting LVM partitions is as follows: The disk partition (fdisk) -- create a physical volume (pvcreate) -- create a volume group (vgcreate) -- Create a logical volume (lvcreate) -- file system (mkfs) -- mount file system (Mount) -- Add to file system list (/etc/fstab) 1. use the partitioning tool fdisk to create the LVM partition (LVM, the regular partition type is 8e). 2. create a physical volume Pvcreate /dev/sda1 /dev/sdb1 3. create volume groups Vgcreate vg0 /dev/sda1 /dev/sdb1 4. activate volume groups Vgchange -ay vg0 5. create logical volumes Vgdisplay vg0 You can get the PE value of this volume group. Lvcreate -l 1192330, -n, lv0, vg0 This command creates the logical volume named lv0 in the volume group vg0, PE size 1192330, and the device entry is /dev/vg0/lv0 (vg0 is the volume group name, lv0 is the logical volume name). 6. create file systems Mkfs.ext3 /dev/vg0/lv0 7. after you create the file system, you can load and use it MKDIR /mnt//lvs Mount /dev/vg0/lv0 /mnt/lvs 8., if you want the system to load the filesystem automatically when you start it, you also need to add content to the /etc/fstab: # VI /etc/fstab /dev/vg0/lv0 /mnt/lvs ext3 defaults 12 New hard disk extensions LVM Step: 1, format second hard disk, all divided into one zone, disk format changed to 8e Disk /dev/sdb: 10.7 GB, 10737418240 bytes 255 heads, 63 sectors/track, 1305 cylinders Units = cylinders, of 16065 * 512 = 8225280 bytes Sector size (logical/physical): 512 bytes / 512 bytes I/O size (minimum/optimal): 512 bytes / 512 bytes Disk identifier: 0x45c5ab54 Device, Boot, Start, End, Blocks, Id, System /dev/sdb1 1130510482381, 8e, Linux, LVM # partprobe /dev/sdb 2, add to LVM [root@ecdata pvcreate /dev/sdb1 ~]# Physical volume, /dev/sdb1, successfully created [root@ecdata vgdisplay ~]# --- Volume group --- VG Name VolGroup System ID Format lvm2 Metadata Areas 1 Metadata Sequence No 3 VG Access read/write VG Status resizable MAX LV 0