单片机供电规则(国外英语资料).docVIP

单片机供电规则(国外英语资料) The C8051F microcontroller is 3.3V low power consumption, high speed MCU, and the power supply 5V we used in the past the traditional low-speed microcontroller in pin processing and PCB layout will have some differences, we summed up the experience, available to everyone, in order to avoid detours in application design. First, the power and ground handling 1, analog and digital power supply can be used separately, respectively, two power supply voltage source, but the difference between the two power supply voltage must meet specified in the data sheet (0.5V, less than 0.3V is ideal). In actual application, analog power and digital power supply can come from the same voltage regulator. Only simple filter between AV+ and VDD is very effective. A small inductance is added here, or a low resistance (usually 2 ohms, and enough parasitic inductance is required). ) this approach reduces both cost and volume. (for this point, you can refer to the power section of the schematic of C8051Fs various target boards). 2, in the ground line, analog and digital to separate wiring, and then at one point through magnetic beads connected, in practical applications can also use 0 ohm wire wound resistance connection. The winding resistance to parasitic inductance, in addition, attention must be paid to the wire in the wiring should be thick, or the covering power line, try to coarse, and between MCU power supply and all and each peripheral integrated circuit of VDD and GND between the decoupling capacitor. 3, if the devices used are analog power, analog, digital power, and digital ground, all of these pins must not be left unconnected and must be connected. Two, in the harsh environment using C8051F devices, in the design of PCB should pay attention to those problems? When using C8051F devices in harsh conditions, we provide you with general recommendations as follows: 1) a decoupling capacitor of 0.1 F and 1 F is placed at each power pin of the device, and as close to