大梁裂缝的原因分析及加固处理(国外英语资料).docVIP

大梁裂缝的原因分析及加固处理(国外英语资料) Cause analysis and reinforcement treatment of girder cracks Abstract: This paper analyzes the cracks of a project girder, and introduces the reinforcement and construction methods. Key words: crack analysis of beam; QR type construction engineering; structural adhesive reinforcement; treatment The comprehensive office building of a technical school in Henan, Xinxiang province is a six story brick concrete structure, in which the width of the classroom is 9.9m * 6.5m, the span of the girder is 6.5m, the beam height is 600mm, and the girders are all made of C25 on-site mixing concrete pouring. The project was put into operation in 1997, four years later, the four layer A - B the second and the third, fifth and the sixth axis, C - D, the second and the third five and six axis, five A - B, and on the bottom of beam and the beam axis beam side irregular longitudinal cracks and diagonal cracks, constitute a serious the hidden danger to the safety engineering. Xinxiang construction quality supervision station, Xinxiang architectural design and Research Institute experts on-site investigation, reinforcement program proposed by our company for reinforcement construction. The reinforcement will be introduced. 1. scene investigation The 11 frame girder beam bottom longitudinal maximum crack width of 0.8mm, seam depth of 30 - 50mm, the crack cut found beam bottom reinforcement rust phenomenon and local corrosion. The 1.2 ends of the oblique beam the maximum crack depth of 20 joints was 0.5mm, 40mm, will crack scuttling, also found stirrup rust phenomenon. 1.3, according to verification, the main structure of concrete pouring concrete, coincides with the winter, the temperature is low, on-site mixing concrete mixed with chloride ion antifreeze, concrete related technical information is complete. After the quality inspection departments on the ten beams rebound, the beam concrete mark meets the design requirements. The ten frame girder 1.4 cracks, especial