超过254台电脑局域网IP设置(国外英语资料).docVIP

超过254台电脑局域网IP设置(国外英语资料) Here is the reference: Handle network mask set: 255.255.255.0 can form a maximum of only 253 nodes in the lan. Handle network mask set: 255.255.254.0 can form a maximum of only 508 nodes in the lan. Handle network mask set: 255.255.252.0 can form a maximum of only 1020 nodes in the lan. Subnet mask 1111111100000000 1111111000000000 1111110000000000 How many subnet masks and IP settings are most appropriate for a company with 530 computers to form a peer to peer LAN? The subnet mask doesnt say, and the result is calculated before, that is, 255.255.252.0 Now, to be sure how IP is allocated, first of all, select a B class IP section, and heres the 168.168. X. Y. Thus, the key to the first two sections of IP is to determine the third paragraph, as long as the network identity is the same. First, to determine the network identity. (we handle the subnet mask in 1 and IP in the N on the 0, and * corresponding, as follows:) 255.255.252.01111111100000000 168.168.x.y10111100.nnnnnn**.******** Network identifier10111100.nnnnnn00From this we can see that the third section of N can be filled (only 0 and 1), and we will fill in 0. The third paragraph can be filled (00, 01, 10, 11), so our IP is 168.168.0.y ~ 168.168.3.y. The range of Y is theoretically 0~255. (but the beginning of IP 0 and the end of IP 255 can not be used), the number of PC can accommodate 4X256 - 2 = 1022 units, and 530 is sufficient! 10.0.0.0/8:10.0.0.0 to 10.255.255.255 172.16.0.0/12:172.16.0.0 to 172.31.255.255 192.168.0.0/16:192.168.0.0 to 192.168.255.255 530 computers make up a peer-to-peer LAN. How should the subnet mask and the IP address be located? First, lets take a look at the IP and subnet masks (A/B/C three is a commonly used IP) Class a 1.0.0.0 to 127.255.255.255 is characterized by its binary representation of the highest bit of 0 The B class 128.0.0.0 to 191.255.255.255 feature is the highest of its binary representations