钢筋绑扎搭接连接规范_百度文库_20140808_094148(国外英语资料).docVIP

钢筋绑扎搭接连接规范_百度文库094148(国外英语资料) Specification for steel strapping and lap joint The mechanism of reinforcement and lap joint of steel bars? (1) the microscopic mechanism of lapping force transfer? What??????????? (2) the trend of splitting and separation of lapping reinforcement and the mechanism of steel lapping force transfer ??? (1) lapping force transfer model; ??????????????????????????????????????? (2) the limit state of lapping force transfer and the mechanism of steel lapping force ?? (1) joints, transverse cracks and longitudinal cracks? ????????????????????? (2) joint damage and cracking bulge crack? State of graduate employment season book opens your resume career journey Raiders interview questions written professional guidance of civil servants area overlap region? 9.4.1 steel connections can be divided into two categories: strapping, lap joint, mechanical connection, or welding. The type and quality of mechanical connections or welded joints shall be in accordance with the current relevant standards of the state. The joints of the stress steel bar should be located in the less stressed place. Less joints should be installed on the same steel bar. ?? 9.4.2 axial tension and small eccentric tension due to tie rod (such as truss and arch pull rod) longitudinal reinforcement shall not use strapping lap joint. When the diameter of tension bar d 28mm and the diameter of compression bar d 32mm, binding lap joint shall not be used. 9.4.3? In the same component, the binding and lap joint of the adjacent longitudinal force steel bars should be staggered. The length of the connecting section of the steel bar binding lap joint is 1.3 times of the lap length, wherein the lap joint of the overlap joint located at the length of the connecting section is in the same row Junction section. The percentage of overlap area of longitudinal reinforcement in the same connection section is the ratio of the longitudinal reinforcement section area to the cross-section