调节阀选用(国外英语资料).docVIP

调节阀选用(国外英语资料) Control valve selection common sense Selection of regulating valve detailed examination content (115 questions) 1 executive body (1) drive mode selection: electric, pneumatic, hydraulic decisions? (2) whether the electric actuator chooses the normal type or the electronic structure? (3) whether the electric actuator is right angle stroke or straight stroke? (4) is the angle stroke electric actuator directly connected or crank connecting rod type? (5) the selection of electric actuator signals: electric II, electric III, or other (6) electric actuator, explosion proof or not? (7) selection of servo amplifier? (8) do I need a position feedback signal? (9) do we need hand operation? (10) pneumatic actuator, diaphragm type and piston type decision? (11) the selection of pneumatic piston actuator type and two bit type; (12) the determination of the straight stroke and angular stroke of the pneumatic piston actuator? (13) pneumatic piston actuator with spring and no spring type selected? (14) pneumatic actuator is an old structure of single spring or a small structure with many springs. (15) the selection of positive action and reaction? (16) the selection of spring range (involving calculation)? (17) the selection of working spring range (involving calculation)? (18) is it necessary to lengthen the bracket? (19) selection of the specification of the executing agency (involving calculations)? (20) does the actuator match the standard with the valve, or does it reduce or increase? ` M+, I4, B0, e., X (21) gas signal size decision? (22) the requirement of gas signal interface? 2 _W o) l x) P E0 B7 P |-) (23) the selection of stroke (angle)? (24) the size of gas source? X8 S3 i+ i% #];]8}4 j/ w T! (25) speed requirement? (26) are environmental conditions met? $U (d#, 7, M+, f-, x4, n) (27) are the dimensions limited or not? (28) whether the weight is limited or not? 0 x, R7, P, _5, W., I2, O3, O8, C9, W (29) for color requirements? L8 Q- ^1.2 _ \; the upper co